IMS GCF测试如何通过看case procedure来得知哪些field/IE必须带 - Part1

yyh19820713

在做GCF的IMS测试时，有时遇到IE mismatch或messageinvalid这样的错误，但是如果打印不全，就不知道到底mismatch在哪里或者哪个IE导致invalid了。有时mismatch的IE太多，就不知道哪个真正matters.

根本方法是查看这个case的详细步骤，看到底哪个IE必须要带，哪个IE不需要。

以IMS emergency registration/call的case 19.5.1为例，现在34.229-1里找到test procedure：

--------------clip--------------

19.5.1      New initial emergencyregistration / UE obtains from the serving IP-CAN an IP address different thanthe IP address used for the emergency registration

Test procedure

applicablefor a UE with E-UTRA support (TS 34.229-2 [5] A.18/1)

1-15) UE executes the procedures described in TS 36.508 [94] table 4.5A.4.3-1 steps 1 to 15 for EPS emergency bearer context activation, IMS emergencyregistration and subsequent IMS emergency speech call establishment with PSAP

16) Call isreleased on the UE. SS waits for the UE tosend a BYE request.

17) SS responds to the BYE request with valid 200 OK response.

Expected sequence

Step	Direction		Message	Comment
	UE	SS
1			User initiates  an emergency call
2-10			Steps defined  in annex C.20 followed by the steps defined  in annex C.22	IMS emergency registration by the UE followed by IMS emergency call  setup with PSAP. Referred from 36.508 [94] table 4.5A.4.3-1 for a UE with E-UTRA  support.
11			void
12			void
13-17			Steps defined  in annex C.32	Make the UE  release the call including EPS Bearer Deactivation procedure according to TS  36.508 [94] subclause 4.5A.15.

--------------clip--------------

测试步骤里提到具体步骤在C.20,C.22,C.32,其中C.20是注册的步骤，大家以C.20为例：

--------------clip--------------

C.20 GenericTest Procedure for IMS emergency registration

Test procedure:

1)   SS waits for the UE to send an initial REGISTER request.

2)   The SS responds to the initial REGISTER request with avalid 401 Unauthorized response.

3)   TheSS waits for the UE to set up a temporary set of security associations and tosend another REGISTER request over those security associations.

4)   TheSS responds to the second REGISTER request with valid 200 OK response, sentover the same temporary set of security associations that the UE used forsending the REGISTER request.

Expected sequence:

Step	Direction		Message	Comment
	UE	SS
1	à		REGISTER	The UE sends  initial IMS emergency registration
2	ß		401  Unauthorized	The SS responds  with a valid AKAv1-MD5 authentication challenge and security mechanisms  supported by the network.
3	à		REGISTER	The UE  completes the security negotiation procedures, sets up a temporary set of SAs  and uses those for sending another REGISTER with AKAv1-MD5 credentials.
4	ß		200 OK	The SS responds  with 200 OK.

Specific Message Contents:

REGISTER (Step 1)

Use thedefault message “REGISTER” in annex A.1.1 with condition A1 "Initial unprotected REGISTER"and condition A7 “Initial IMS emergencyregistration” simultaneously applying.

The contents of From and To headers of the REGISTERrequest shall be according to condition A7.

REGISTER (Step 3)

Use the default message “REGISTER” in annexA.1.1 with condition A2 "Subsequent REGISTER sent over securityassociations" and condition A7 “Initial IMS emergency registration”simultaneously applying.

The contentsof From and To headers of the REGISTER request shall be according to conditionA7.

200 OK for REGISTER (Step 4)

Use the default message “200 OK forREGISTER” in annex A.1.3 with condition A3 “Response for an emergencyregistration”.

--------------clip--------------